A – Tank BracketB – Extension armC – Adjustor bracketD – Adjustment knobE – Camera platformF – Tank bracket screws |
- Leave fuel cap on for entire process
- Remove the bolts on your fuel filler cap that align with the tank bracket (A). The number of bolts vary from bike to bike (2 or 3 bolts).
- Before bolting on tank bracket (A) check for correct diameter and length of supplied bolts.
- Install tank bracket, carefully tightening the bolts with minimum force required. If for some reason the bolts don’t fit right, do not force them on.
- Remove adjustor bracket (C) from the extension arm (B)
- Before the next step, be careful when mounting your camera as they are mostly plastic. If you strip the bottom mounting hole, your camera will not be able to be repaired.
- Turn your camera upside down and place camera platform (E) on bottom of camera. Place the adjustor bracket (C) on the camera platform (E) and install the screw through both pieces and install the supplied bolt (G).
- Now you can assemble the adjustable bracket (A) back on the extension arm (B). Make sure to use the supplied spacer and lockwasher.
Tightening The Camera
Tighten knob (D) and rotate camera backwards while holding the knob tight. Rotate camera forward while continuing to tighten. This step can be repeated until the camera is tight.
Removing Camera
Rotate camera backwards as you loosen knob.
Click here to purchase the SportBikeCam Front Mount.
A – Main Bracket B – 5/16 Screw C – Adjustor Bracket D – Adjustment Knob E – Camera Platform | F – Extension arm G – Adjustment Spacer H – 8MM bolts I – Footpeg Spacers J – Optional Nuts |
- Remove the left passenger peg bracket.
- Place washers on bolts (H), insert through main bracket (A), install spacers (I) and bolt to stock passenger peg mounting holes. If the stock holes are not threaded you can use the nuts (J) to secure the assembly.
- Now it’s time to install the camera mounting hardware.
- Before the next step, be careful when mounting your camera as they are mostly plastic. If you strip the bottom mounting hole, your camera may not be able to be repaired.
- Turn your camera upside down and place camera platform (E) on bottom of camera. Place the adjustor bracket (C) on the camera platform (E) and install the screw through both and tighten assembly to camera. Now you can assemble the adjustor bracket (C) onto the extension arm (F).
- Make sure to use the supplied spacer and lockwasher.
Tightening The Camera
Rotate camera backwards, tighten knob (D). Rotate camera forward while continuing to tighten. This step can be repeated until the camera is tight.
Removing Camera
Rotate camera backwards as you loosen knob.
Don’t forget to use the velcro safety strap to secure the camera to the main bracket. You can remove the small front screw on the angle adjuster (C) to swivel a video camera or mount a still camera.
Click here to purchase the SportBikeCam Rear Mount.